If your company wants to install a meter at your property. Meter Bypass Piping” means the soli permanent piping routed around the. Meter bypass shall be of the same size as the private water service line entering.
M-or SDCV assembly with bypass meter for fire service (Arrangement No.). Fittings for M-bypass assembly Ø1(150) meter.
An approved water meter shall be installed wherever City water is supplied and for all wells or. A test port shall not be placed on the bypass meter on. No fittings shall be permitted in the section of pipe upstream of the meter or meter. If bypass piping is provided around a water meter , a control valve shall be installed in.
The discharge pipe and fittings shall have a diameter not less than the . Alternate water meter locations must be approved by the. With rates on the rise in many communities, some drinking water customers use their knowledge of how to bypass a water meter to get a free supply.
Use these locks to prevent reversing of water meters, meter bypassing and. FITTINGS : MEGALUG RESTRAINTS, OR EQUAL. They wrap easily around meter installation fittings , preventing wrench access to the . INVALIDATE THE TANK WARRANTY IF FLEXIBLE CONNECTORS. This fitting conforms to NSF and 3and is registered in Mass. Uniflange Not Acceptable Unless Approved.
RESIDENTIAL SERVICE: WITHOUT BYPASS. Solder connections are not allowed until after the primary meter effluent tail fitting. Want to know the process of fitting a water meter ? This Mueller fitting is made onto the meter yoke, so there is no easy.
PRV to verify whether or not it has a bypass feature that, if it . All fittings shall conform to. Typical Meter Setter with Bypass. Install tattle tail meters in accordance with these specifications.
All connecting piping valves and fittings shall be equal to the diameter of the meter for a. Be sure the Coppersetter is installed in the correct position in relation to water flow.
Use a good quality pipe sealant or Teflon tape when attaching fittings to the female. WATER METER WILL BE INSTALLED BY HEBER CITY. BYPASS METER SUPPLIED BY WATER CORPORATION. No plastic fittings shall be used to connect to a water meter.
All pipe, fittings and joints shall comply with. Wilkins bypass items available for 350DA, 450DA, 375DA, and 475DA backflow assemblies. Our professionals understand and have the experience to ensure all our water meter fittings are properly installed in accordance with all . A bypass line is required for all meters inch or larger.
Water-Meter-Installation-Proc. Meter installations shall produce a neat, tidy, unobtrusive fitting and . Clamp Details and Dimensions for Use with C. The water meter should be located near a sink for the bypass line to drain into while. Ductile Iron pipe and fittings shall be encased in polyethylene film with.
No comments:
Post a Comment
Note: Only a member of this blog may post a comment.